Dodge Dart Forums banner
1 - 1 of 1 Posts

· Registered
7 Posts
Discussion Starter · #1 ·
Im gonna cut off my muffler in a few days, once my exhaust Y(one inlet and two outlets) comes in. Im not gonna weld but instead im gonna use clamps. I found pre bent pipes at the local pep boys and they look like all the angles that im gonna use. A few 90 degree angles and some straight pipe. I just was curious if someone who already did this has any tips or advice to maybe help the process go along a little smoother. By the way im keeping the resonator.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.