[blackwidow]

Our exhaust just showed up from magnaflow, pics coming soon of the setup pre- and after install. We will also make a video clip for you as well before and after, this should bolt up nicely to make a sweet sound in conjuction with the new intake coming soon from k&n or others depending on which way we go with motor build.

 

[jkelly16]

You could take pics all the way through the install and make it a "How To" for others that may want to change theirs out. Good luck and hope it's not too tough.

 

[blackwidow]

Here is a few pics of our old one off 3" engine back exhaust, cat delete and using a magnaflow turbo friendly muffler

and a sound clip

http://www.facebook.com/photo.php?v=444667942240950&set=vb.100000932447879&type=3&theater

 

[iZimm27]

the same one i have on mine.

 

[blackwidow]

I am uploading pics now i will post full install tomorrow heres a quick video clip of new system on the car

 

[blackwidow]

Step 1-- Car on lift

Step 2-- Remove the bolts from flex pipe flange and mid pipe flange

Step 3--- removed bolts and removed pipe from hangers we also supported exhaust with a jack at this point

Step 4--- Removal of muffler from the 3 rear rubber hangers

Step 5-- Stcok exhaust is out of car, pretty quick and easy

Step 6--- factory tips

Step 7 -- removed tips (3 bolts)

Step 8--Alignment of pipe 1 of the midpipes to flex pipe flange

Step 9--- We have forward piece of midpipe bolted to flex pipe flange and in the 2 rubber hangers

Step 10-- fit the read mid pipe to the forward mid pipe and clamp loosely for temp fitment

 

[blackwidow]

Step 11--- Align Muffler to rear mid pipe and also hang muffler from forward rubber hanger

Step 12-- Connect both rear pipes to muffler and install into rear rubber hangers

Step 13--- Srat to tighen all the clamps for final fitment

Step 14--- Start aligning all the parts so tips fit properly from rear fascia

Step 15-- as you can see after 30 minutes of playing we couldnt get drivers side to fit peoperly so.....

Step 16-- a small notch and a nice weld and we were in buisness, these pics and a writeup will be going to the office of magnaflow, we arent the first people to have this issue..

 

[jkelly16]

Thanks for the pics, that should help anyone that has a question about how the exhaust fits.

 

[dleininger]

Nice writeup! Yeah I've heard about the fitment issues with this setup...hopefully MF fixes that.

Congrats on the new exhaust though!

 

[N20Dart]

Very nice! Got to have that, as so as they fix the fit issues first lol

 

[iZimm27]

Very nice! Got to have that, as so as they fix the fit issues first lol

must be an individual issue...mine fit in better than the OEM exhaust....like a glove

 

[Dartman13]

What kind of HP did it add? Was it noticeable? I'm looking into get this for my car.

 

[Arrrggghhhh]

sounds great! is it much louder inside? ie. at freeway speeds is it tolerable inside?

 

[aeary]

sounds great! is it much louder inside? ie. at freeway speeds is it tolerable inside?

Would like confirmation on this as well

 

[blackwidow]

it isn't that much louder in the cabin than stock, as far as dyno unfortunately the exhaust was hung at same time as intake R&D was being done our stock baseline was roughly 156 if I remember at front wheels and we added roughly 10hp between the 2 at the front wheels I will have to double check....